7-2 Clean Up While Power On
7-2-1 Nipping Plate and Nipper Jaw Clean Up
Nipping plate or nipper jaws must be cleaned
after binding finished.
WARNING
- Depress stop button before cleaning.
- Put gloves on your hands. You might
unexpectedly touch melt tank which is
heated up to around 200 degrees. High
temperature can cause severe skin
burn.
Necessary Tool : Cloth
1.
Depress stop button.
2.
Confirm clamper stops over level plate.
3.
Confirm nipping unit is at lower point.
NOTE
- If nipping unit is at upper position, release
emergency stop, close safety cover and de-
press nipping unit up/down button once to
lower nipping unit.
- When nipping unit is at lower position, five
screws on nipping unit appear.
4.
Wipe off dust such as glue or paper dust
on nipping plate and nipper jaws with
cloth.
Clamper
Nipper Plate
Stop Button
55
7. After Binding Finish
Stop Button
Screws
Nipper Up/Down Button