Horizon Fitness Perfect Binder BQ-260 Manual page 40

4. Set Up BQ-260
4-7 Test Binding
4-1
When with milling mode is selected,
depress milling start button.
- Lamp in milling start button will turn off
and milling cutter will start rotating.
- Blower pump will start at same time and
dust bag swells with air.
4-2
When without milling mode is selected,
lamp in milling start button will not be on.
5.
Depress start button.
- Confirm that lamp on start button is on
and then depress start button.
- Clamper will start for binding and returns
to its home position (start position) after
binding.
6.
Confirm that book is ejected at vertical
stacker unit after binding finished.
7.
Check binding.
- When binding result does not satisfy your
requirement, perform "4-1" to "4-7" (page
22 to 34) again to readjust each unit on
binder.
8.
Depress stop button.
9.
Take out book from vertical stacker unit.
Level Plate Button
Start Button
Stop Button
Vertical Stacker Unit
34
Milling Start Button