6. Special Binding Method
6-3 To Adjust Finish Condition of Spine
This section shows how to adjust finish
condition of spine by changing nipping
height or angle when the spine corner is too
sharp, or spine corner is round.
NOTE
Sheet quality and glue application thickness
influence the finish condition of spine.
1.
Move cover feeding unit to the front side
to provide access space under nipping unit.
2.
Turn adjust bar to the required direction
with spanner (17 cm).
3.
Make sure of the finish condition by test
binding. After that, set cover feeding unit.
Dial Number
0 : Standard
- : Nipper lowers by turning adjust bar counterclockwise (arrowed direction)
and spine becomes rounder.
+ : Nipper rises by turning adjust bar clockwise and spine becomes sharper.
Lower Section of
Nipping Unit
Adjustment of the
Left Side of Nipper
52
Adjust Bar
Dial
Hand
Adjustment of the
Right Side of Nipper