Control Panel - Horizon Fitness Perfect Binder BQ-260 Manual

1-2 Control Panel

1 2
Trouble Monitor
7
1.Gluing Length Adjusting Knobs
Used to adjust spine glue length.
2.Milling Start Button
Used to start to rotate milling cutter.
3.Cover Single Feed Button
Used to feed one cover sheet from cover
feeder with automatic cover feeding
mode.
4.Nipper Up/Down Button
Used to raise or lower nipper unit for
setting up nipping unit.
5. Nipping Time Control Knob
Used to control nipping time.
6. Nipping Mode Select Switch
Used to select nipping mode. Three
different modes, With milling binding
mode, Signature binding mode and Pad
binding mode can be selected.
7. Trouble Monitor
(Please refer to next page.)
3 4 5
8 9 10 11
3
1. Machine Parts Descriptions
6
12 13
8. Milling Mode Select Switch
Used to select milling mode, with milling
or without milling.
9.Level Plate Mode Select Switch
Used to select reset mode of Level Plate
after one complete cycle of binding
automatic or manual.
10. Cover Feed Mode Select Switch
Used to select cover feed mode, auto-
matic or manual
11. Clamper Pin On/OFF Switch
Used to turn on/off clamper pin which
holds stock in clamper when without
milling mode is selected..
12. Nipping Delay Time Control Knob
Used to control nipping delay time
length.
13. Pad Binding Lamp
This lamp turns on when pad binding
mode is selected.