Horizon Fitness Perfect Binder BQ-260 Manual page 60

7. After Binding Finish
7-1 Glue Supply
Glue must be supplied in melt tank when
binding finished.
WARNING
- Put gloves on your hands when you
supply glue in melt tank which is
heated up to around 200 degrees. High
temperature can cause severe skin
burn.
- Depress emergency stop switch before
supplying glue.
1.
Open malt tank cover.
2.
Place glue on supply area in melt tank.
NOTE
- Supply glue into melt tank piece by piece
not to supply glue over maximum glue level.
- Glue level must be lower than RED line on
glue level indicator.
- Use only Horizon Glue (HM-110).
3.
Close melt tank cover.
Melt Tank Cover
Melt Tank
54
Glue Supply Area