Commissioning; Processing The Input Signals Of Pressure Sensors; Procedure For Commissioning - Festo CPX Series Manual

7. Pressure sensor module CPX-4AE-P
7.4

Commissioning

7.4.1 Processing the input signals of pressure sensors

7.4.2 Procedure for commissioning

Festo P.BE-CPX-AX-EN en 1107f
The analogue values of the 4 pressure sensors are
transmitted from the CPX terminal to the control system as
input words (4 analogue inputs, 64 bits). Each pressure
sensor module occupies 4 input words for this in the address
range.
The position of the input words in the address range depends
on the field bus used (see manual for the field bus node).
An overview of setting up the pressure sensor module
CPX-4AE-P is provided in the following section. Detailed
information about making settings via parameterisation is
provided in section 7.4.3.
1. Connect the pneumatic hoses and close the unused
connections with blanking plugs.
2. Settings for the pressure sensor module can be made via
the Handheld (CPX-MMI), a PC (with the Festo
Maintenance Tool CPX-FMT) or via the field bus or the
network:
– Connect the Handheld or a PC to the CPX terminal or
establish a field bus or network connection with your
PLC.
7-7