Festo CPX Series Manual page 41

1. Overview and connection technology I/O modules
Dismantling
1
Sub-base
2
Screws
3
Electrical plug
connector
4
Electronics
module
5
Contact rails
6
Manifold base
Fig. 1/7: Fitting/removing the I/O module
Festo P.BE-CPX-AX-EN en 1107f
Dismantle the sub-base as follows (see Fig. 1/7):
1. Loosen the 4 screws in the relevant sub-base with a TORX
screwdriver size T10.
2. Pull the sub-base carefully and without tilting away from
the electrical plug connection of the electronic module.
Only in cases where the electronic module is to be removed:
Pull the electronic module carefully and without tilting
•
away from the contact rails of the manifold sub-base.
1
3
2
4
5
6
1-21