Festo CPX Series Manual page 125

4. Analogue input module CPX-4AE-I
4.3.1 DIL switch settings
1
DIL switch 0:
Signal range of
analogue input
0, 1
2
DIL switch 1:
Signal range of
analogue input
2, 3
Fig. 4/1: DIL switches in the electronic module
(further information on 1 and 2 see following pages)
Festo P.BE-CPX-AX-EN en 1107f
2 DIL switches are available for configuring the analogue
input modules. These are located on the top of the electronic
module.
4
AI- - I
ON
1 2
ON
1 2
Proceed as follows:
1. Switch off the power supply.
2. Remove if necessary the fitted sub-base (see "Fitting"
section 1.3).
3. Set the DIL switch elements in accordance with the
instructions on the following pages.
4. Refit if necessary the sub-base (see "Fitting" section 1.3,
tightening torque 0.9 ... 1.1 Nm).
1
2
4-5