Assembly; Installation; Commissioning; Parameterisation - Festo CPX-AP-I-4DI4DO-M8-3P Instructions And Operating Manual

Assembly

Connection for outputs [X4] ... [X7]
Socket M8, 3-pin, A-coded
Tab. 9 Connection for outputs
6 Assembly
• Assemble the module as outlined in the "Instruction manual for automation system
CPX-AP"è 1.1 Applicable documents.
7

Installation

• Carry out the installation according to the "Instruction manual for automation system
CPX-AP"è 1.1 Applicable documents.
8

Commissioning

• Commission the automation system CPX-AP in accordance with the "Instruction manual for auto-
mation system CPX-AP" è 1.1 Applicable documents.
Behaviour of the display components of the module after error-free commissioning
[MD]
Illuminated green
Tab. 10 Behaviour of the LED displays of the module after error-free commissioning
Information on troubleshooting in the event of incorrect behaviour:
è Instruction manual for automation system CPX-AP
è 10 Diagnostics and fault clearance
9

Parameterisation

Various parameters are available for reading out information about the modules in an automation sys-
tem CPX-AP and adapting the modules to the application situation.
Write access to the parameters is typically performed by the higher-level controller using the device
descriptions specific to the host system.
10
Signal
1 n.c.
3 0 V DC outputs
4 Output 0
...
3
[PL]
Illuminated green
Festo — CPX-AP-I-4DI4DO-M8-3P — 2019-06