Configuring The Ospf Screen - ZyXEL Communications ZyWall 110 User Manual

Enable OSPF.
1
Set up the OSPF areas.
2
Configure the appropriate interfaces. See
3
Set up virtual links, as needed.
4

11.7.1 Configuring the OSPF Screen

Use the first OSPF screen to specify the OSPF router the Zyxel Device uses in the OSPF AS and maintain
the policies for redistribution. In addition, it provides a summary of OSPF areas, allows you to remove
them, and opens the OSPF Add/Edit screen to add or edit them.
Click Configuration > Network > Routing > OSPF to open the following screen.
Figure 293 Configuration > Network > Routing > OSPF
The following table describes the labels in this screen. See
information as well.
Table 145 Configuration > Network > Routing Protocol > OSPF
LABEL
OSPF Router ID
Redistribute
Active RIP
Chapter 11 Routing
Section 10.5.1 on page
DESCRIPTION
Select the 32-bit ID the Zyxel Device uses in the OSPF AS.
Default - the first available interface IP address is the Zyxel Device's ID.
User Defined - enter the ID (in IP address format) in the field that appears when you select
User Define.
Select this to advertise routes that were learned from RIP. The Zyxel Device advertises
routes learned from RIP to Normal and NSSA areas but not to Stub areas.
ZyWALL USG Series User's Guide
423
306.
Section 11.7.2 on page 424 for more