Port Group - ZyXEL Communications ZyWall 110 User Manual

Hide thumbs Also See for ZyWall 110:
Table of Contents

Advertisement

Each field is described in the following table.
Table 104 Configuration > Network > Interface > Port Configuration
LABEL
Edit
Name
Interface
Type
Settings
Status
Apply
Reset

10.4 Port Group

Note: See
Section 1.1 on page 28
Figure 241 Configuration > Network > Interface > Port Group (USG2200-VPN)
The representative interfaces are shown at the top of the screen and the physical ports are shown at the
bottom. You can set port grouping for ports 1~16. Ports 1~4 are 1G fiber ports and ports 5~16 are 1G
Chapter 10 Interfaces
DESCRIPTION
Select an entry, and click this button to configure the speed and the duplex mode of the
Ethernet connection on this port.
This field displays the name of the port.
This field displays the interface for the port.
This field displays the cable type that is used on the port.
Select the speed and the duplex mode of the Ethernet connection on this port. Choices
are Auto Negotiate, 1000Mbps-Full Duplex, 100Mbps-Full Duplex, 100Mbps-Half Duplex,
10Mbps-Full Duplex, and 10Mbps-Half Duplex.
Selecting Auto Negotiate allows one port to negotiate with a peer port automatically to
obtain the connection speed (of up to 1000M) and duplex mode that both ends support.
When auto-negotiation is turned on, a port on the Zyxel Device negotiates with the peer
automatically to determine the connection speed and duplex mode. If the peer port does
not support auto-negotiation or turns off this feature, the Zyxel Device determines the
connection speed by detecting the signal on the cable and using half duplex mode. When
the Zyxel Device's auto-negotiation is turned off, a port uses the pre-configured speed and
duplex mode when making a connection, thus requiring you to make sure that the settings
of the peer port are the same in order to connect.
This field displays the speed and the duplex mode of the Ethernet connection on the port.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
to see which models support port group.
ZyWALL USG Series User's Guide
303

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents