Vpn Express Wizard - Summary - ZyXEL Communications ZyWall 110 User Manual

• Secure Gateway: Any displays in this field if it is not configurable for the chosen scenario. Otherwise,
enter the WAN IP address or domain name of the remote IPSec device (secure gateway) to identify
the remote IPSec router by its IP address or a domain name. Use 0.0.0.0 if the remote IPSec router has
a dynamic WAN IP address.
• Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password. Use up
to 128 case-sensitive ASCII characters or up to 128 pairs of hexadecimal ("0-9", "A-F") characters.
Proceed a hexadecimal key with "0x". You will receive a PYLD_MALFORMED (payload malformed)
packet if the same pre-shared key is not used on both ends.
• Local Policy (IP/Mask): Type the IP address of a computer on your network that can use the tunnel.
You can also specify a subnet. This must match the remote IP address configured on the remote IPSec
device.
• Remote Policy (IP/Mask): Any displays in this field if it is not configurable for the chosen scenario.
Otherwise, type the IP address of a computer behind the remote IPSec device. You can also specify
a subnet. This must match the local IP address configured on the remote IPSec device.

5.3.5 VPN Express Wizard - Summary

This screen provides a read-only summary of the VPN tunnel's configuration and commands that you
can copy and paste into another ZLD-based Zyxel Device's command line interface to configure it.
Figure 131 VPN Express Wizard: Summary
• Rule Name: Identifies the VPN gateway policy.
• Secure Gateway: IP address or domain name of the remote IPSec device. If this field displays Any,
only the remote IPSec device can initiate the VPN connection.
• Pre-Shared Key: VPN tunnel password. It identifies a communicating party during a phase 1 IKE
negotiation.
• Local Policy: IP address and subnet mask of the computers on the network behind your Zyxel Device
that can use the tunnel.
Chapter 5 Quick Setup Wizards
ZyWALL USG Series User's Guide
160