Configuring The Ospf Screen - ZyXEL Communications ZyWALL 1100 User Manual

OSPF Configuration
Follow these steps when you configure OSPF on the ZyWALL/USG.
Enable OSPF.
1
Set up the OSPF areas.
2
Configure the appropriate interfaces. See
3
Set up virtual links, as needed.
4

10.7.1 Configuring the OSPF Screen

Use the first OSPF screen to specify the OSPF router the ZyWALL/USG uses in the OSPF AS and
maintain the policies for redistribution. In addition, it provides a summary of OSPF areas, allows
you to remove them, and opens the OSPF Add/Edit screen to add or edit them.
Click Configuration > Network > Routing > OSPF to open the following screen.
Figure 172 Configuration > Network > Routing > OSPF
The following table describes the labels in this screen. See
information as well.
Table 110 Configuration > Network > Routing Protocol > OSPF
LABEL
OSPF Router ID
Redistribute
Chapter 10 Routing
Section 9.3.1 on page
DESCRIPTION
Select the 32-bit ID the ZyWALL/USG uses in the OSPF AS.
Default - the first available interface IP address is the ZyWALL/USG's ID.
User Defined - enter the ID (in IP address format) in the field that appears when
you select User Define.
ZyWALL/USG Series User's Guide
256
162.
Section 10.7.2 on page 257 for more