ZyXEL Communications ZyWall 110 User Manual page 305

Hide thumbs Also See for ZyWall 110:

Table of Contents

Figure 242 Configuration > Network > Interface > Ethernet

Each field is described in the following table.

Table 105 Configuration > Network > Interface > Ethernet

Configuration / IPv6

Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section

Configuration

for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections

have similar fields as described below.

Double-click an entry or select it and click Edit to open a screen where you can modify the

entry's settings.

To remove a virtual interface, select it and click Remove. The Zyxel Device confirms you

want to remove it before doing so.

To turn on an interface, select it and click Activate.

To turn off an interface, select it and click Inactivate.

Create Virtual

To open the screen where you can create a virtual Ethernet interface, select an Ethernet

interface and click Create Virtual Interface.

Select an entry and click References to open a screen that shows which settings use the

This field is a sequential value, and it is not associated with any interface.

This icon is lit when the entry is active and dimmed when the entry is inactive.

This field displays the name of the interface.

This field displays the description of the interface.

Chapter 10 Interfaces

Section 10.5.4 on page 328

ZyWALL USG Series User's Guide

for an example.

Show Quick Links

Table of Contents

Troubleshooting