ZyXEL Communications ZyWall 110 User Manual page 979

Figure 697 Log Category Settings AP
This screen provides a different view and a different way of indicating which messages are included in
each log and each alert. Please see
Default category includes debugging messages generated by open source software).
The following table describes the fields in this screen.
Table 397 Configuration > Log & Report > Log Setting > Log Category Settings
LABEL DESCRIPTION
System Log Use the System Log drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not log any information for any category for the system log or e-mail
any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts for all categories for
the system log. If e-mail server 1 or 2 also has normal logs enabled, the Zyxel Device will e-mail
logs to them.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and
debugging information for all categories. The Zyxel Device does not e-mail debugging
information, even if this setting is selected.
USB Storage Use the USB Storage drop-down list to change the log settings for saving logs to a connected
USB storage device.
disable all logs (red X) - do not log any information for any category to a connected USB
storage device.
enable normal logs (green check mark) - create log messages and alerts for all categories and
save them to a connected USB storage device.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and
debugging information for all categories and save them to a connected USB storage device.
Chapter 45 Log and Report
Section 45.3.2 on page
ZyWALL USG Series User's Guide
979
967, where this process is discussed. (The