Configuring Rtls - ZyXEL Communications ZyWall 110 User Manual

• Ekahau RTLS Controller in blink mode with TZSP Updater enabled
• Security policies to allow RTLS traffic if the Zyxel Device security policy control is enabled or the Ekahau
RTLS Controller is behind a firewall.
For example, if the Ekahau RTLS Controller is behind a firewall, open ports 8550, 8553, and 8569 to allow
traffic the APs send to reach the Ekahau RTLS Controller.
The following table lists default port numbers and types of packets RTLS uses.
Table 99 RTLS Traffic Port Numbers
PORT NUMBER
8548
8549
8550
8552
8553
8554
8560
8562
8569

9.6.3 Configuring RTLS

Click Configuration > Wireless > RTLS to open this screen. Use this screen to turn RTLS (Real Time Location
System) on or off and specify the IP address and server port of the Ekahau RTLS Controller.
Figure 235 Configuration > Wireless > RTLS
The following table describes the labels in this screen.
Table 100 Configuration > Wireless > RTLS
LABEL
Enable
IP Address
Server Port
Apply
Reset
Chapter 9 Wireless
TYPE DESCRIPTION
TCP Ekahau T201 location update.
UDP Ekahau T201 location update.
TCP Ekahau T201 tag maintenance protocol and Ekahau RTLS Controller user interface.
UDP Ekahau Location Protocol
UDP Ekahau Maintenance Protocol
UDP Ekahau T301 firmware update.
TCP Ekahau Vision web interface
UDP Ekahau T301W firmware update.
UDP Ekahau TZSP Listener Port
DESCRIPTION
Select this to use Wi-Fi to track the location of Ekahau Wi-Fi tags.
Specify the IP address of the Ekahau RTLS Controller.
Specify the server port number of the Ekahau RTLS Controller.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
ZyWALL USG Series User's Guide
293