Add Application Rule - ZyXEL Communications ZyWall 110 User Manual

Table 317 Configuration > Object > Application > Application (continued)
LABEL
Released
Date
Update
Signatures

43.6.1 Add Application Rule

Click Add in Configuration > Object > Application > Application to create a new application rule. In the
first screen you type a name to identify this application object and write an optional brief description of
it.
You then click Add again to choose the signatures that should go into this object.
Figure 577 Configuration > Object > Application > Application > Add Application Rule
The following table describes the labels in this screen.
Table 318 Configuration > Object > Application > Application > Add Application Rule
LABEL
Name
Description
Add
Remove
#
Category
Application
OK
Cancel
Chapter 43 Object
DESCRIPTION
This field shows the date (YYYY-MM-DD) and time the current signature version was released.
If your signature set is not the most recent, click this to go to Configuration > Licensing >
Signature Update > IDP / AppPatrol to update your signatures.
DESCRIPTION
Type a name to identify this application rule. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is case-
_
sensitive.
You may type some extra information on the application object here.
Click this to create a new application rule.
Click this to remove the selected application rule.
This field is a sequential value associated with this application rule.
This field shows the category to which the signature belongs in this application rule.
This displays the name of the application signature used in this application rule.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to exit this screen without saving your changes.
ZyWALL USG Series User's Guide
837