ZyXEL Communications ZyWall 110 User Manual page 852

Figure 589 Configuration > Object > Service > Service
The following table describes the labels in this screen.
Table 330 Configuration > Object > Service > Service
LABEL
Add
Edit
Remove
References
#
Name
Content
Reference
43.8.2.1 The Service Add/Edit Screen
The Service Add/Edit screen allows you to create a new service or edit an existing one. To access this
screen, go to the Service screen (see
Edit icon.
Figure 590 Configuration > Object > Service > Service > Edit
The following table describes the labels in this screen.
Table 331 Configuration > Object > Service > Service > Edit
LABEL
Name
IP Protocol
Chapter 43 Object
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
Select an entry and click References to open a screen that shows which settings use the entry.
This field is a sequential value, and it is not associated with a specific service.
This field displays the name of each service.
This field displays a description of each service.
This displays the number of times an object reference is used in a profile.
Section 43.8.2 on page
DESCRIPTION
Type the name used to refer to the service. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is case-
_
sensitive.
Select the protocol the service uses. Choices are: TCP, UDP, ICMP, ICMPv6, and User Defined.
ZyWALL USG Series User's Guide
851), and click either the Add icon or an
852