ZyXEL Communications ZyWall 110 User Manual page 618

Table 221 Configuration > VPN > IPSec VPN > VPN Connection > Add/Edit (continued)
LABEL DESCRIPTION
Check Port This field displays when you set the Check Method to tcp. Specify the port number to use
for a TCP connectivity check.
Check Period Enter the number of seconds between connection check attempts.
Check Timeout Enter the number of seconds to wait for a response before the attempt is a failure.
Check Fail Enter the number of consecutive failures allowed before the Zyxel Device disconnects
Tolerance
the VPN tunnel. The Zyxel Device resumes using the first peer gateway address when the
VPN connection passes the connectivity check.
Check this Address Select this to specify a domain name or IP address for the connectivity check. Enter that
domain name or IP address in the field next to it.
Check the First and Select this to have the Zyxel Device check the connection to the first and last IP
Last IP Address in
addresses in the connection's remote policy. Make sure one of these is the peer
the Remote Policy
gateway's LAN IP address.
Log Select this to have the Zyxel Device generate a log every time it checks this VPN
connection.
Inbound/Outbound
traffic NAT
Outbound Traffic
Source NAT This translation hides the source address of computers in the local network. It may also be
necessary if you want the Zyxel Device to route packets from computers outside the local
network through the IPSec SA.
Source Select the address object that represents the original source address (or select Create
Object to configure a new one). This is the address object for the computer or network
outside the local network. The size of the original source address range (Source) must be
equal to the size of the translated source address range (SNAT).
Destination Select the address object that represents the original destination address (or select
Create Object to configure a new one). This is the address object for the remote network.
SNAT Select the address object that represents the translated source address (or select Create
Object to configure a new one). This is the address object for the local network. The size
of the original source address range (Source) must be equal to the size of the translated
source address range (SNAT).
Inbound Traffic
Source NAT This translation hides the source address of computers in the remote network.
Source Select the address object that represents the original source address (or select Create
Object to configure a new one). This is the address object for the remote network. The size
of the original source address range (Source) must be equal to the size of the translated
source address range (SNAT).
Destination Select the address object that represents the original destination address (or select
Create Object to configure a new one). This is the address object for the local network.
SNAT Select the address object that represents the translated source address (or select Create
Object to configure a new one). This is the address that hides the original source address.
The size of the original source address range (Source) must be equal to the size of the
translated source address range (SNAT).
Destination NAT This translation forwards packets (for example, mail) from the remote network to a
specific computer (for example, the mail server) in the local network.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
Chapter 30 IPSec VPN
ZyWALL USG Series User's Guide
618