Ap Group - ZyXEL Communications ZyWall 110 User Manual

Each field is described in the following table.
Table 92 Configuration > Wireless > AP Management > AP Policy
LABEL
Force Override AC IP
Config on AP
Override Type
Primary Controller
Secondary Controller Specify the IP address of the secondary AP controller if you set Override Type to Manual.
Fall back to Primary
Controller when
possible
Fall Back Check
Interval
Firmware Updating
Updating Type
Apply
Reset

9.3.3 AP Group

Use this screen to configure AP groups, which define the radio, port, VLAN and load balancing settings
and apply the settings to all APs in the group. An AP can belong to one AP group at a time. Click
Configuration > Wireless > AP Management > AP Group to access this screen.
Figure 228 Configuration > Wireless > AP Management > AP Group
Chapter 9 Wireless
DESCRIPTION
Select this to have the Zyxel Device change the AP controller's IP address on the managed
AP(s) to match the configuration in this screen.
Select Auto to have the managed AP(s) automatically send broadcast packets to find any
other available AP controllers.
Select Manual to replace the AP controller's IP address configured on the managed AP(s)
with the one(s) you specified below.
Specify the IP address of the primary AP controller if you set Override Type to Manual.
Select this option to have the managed AP(s) change back to associate with the primary
AP controller as soon as the primary AP controller is available.
Set how often the managed AP(s) check whether the primary AP controller is available.
Specify how you want the Zyxel Device to upgrade AP firmware.
Select CAPWAP to have the Zyxel Device use CAPWAP (Control and Provisioning of Wireless
Access Points protocol) to automatically update firmware on the managed APs.
Select FTP to allow the managed APs to download the latest firmware from the Zyxel Device
using FTP.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
ZyWALL USG Series User's Guide
279