ZyXEL Communications ZyWall 110 User Manual page 412

Hide thumbs Also See for ZyWall 110:

Table of Contents

Figure 285 Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)

The following table describes the labels in this screen.

Table 138 Configuration > Network > Routing > Policy Route > Add/Edit

Show Advanced

Click this button to display a greater or lesser number of configuration fields.

Settings / Hide

Advanced Settings

Create new Object

Use this to configure any new settings objects that you need to use in this screen.

Configuration

Select this to activate the policy.

Enter a descriptive name of up to 31 printable ASCII characters for the policy.

Select a user name or user group from which the packets are sent.

Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or the

Zyxel Device itself. For an interface, a tunnel, or an SSL VPN, you also need to select the

individual interface, VPN tunnel, or SSL VPN connection.

Source Address

Select a source IP address object, including geographic address and FQDN (group)

objects, from which the packets are sent.

Destination Address

Select a destination IP address object, including geographic address and FQDN (group)

objects, to which the traffic is being sent. If the next hop is a dynamic VPN tunnel and you

enable Auto Destination Address, the Zyxel Device uses the local network of the peer

router that initiated an incoming dynamic IPSec tunnel as the destination address of the

policy instead of your configuration here.

Chapter 11 Routing

ZyWALL USG Series User's Guide

Show Quick Links

Table of Contents

Troubleshooting