ZyXEL Communications ZyWall 110 User Manual page 277

Each field is described in the following table.
Table 91 Configuration > Wireless > AP Management > Mgnt. AP List > Edit AP List
LABEL DESCRIPTION
Create new Object Use this menu to create a new Radio Profile object to associate with this AP.
MAC This displays the MAC address of the selected AP.
Model This field displays the AP's hardware model information. It displays N/A (not applicable) only
when the AP disconnects from the Zyxel Device and the information is unavailable as a
result.
Description Enter a description for this AP. You can use up to 31 characters, spaces and underscores
allowed.
Group Setting Select an AP group to which you want this AP to belong.
Radio 1/2 Setting
Override Group Select this option to overwrite the AP radio settings with the settings you configure here.
Radio Setting
OP Mode Select the operating mode for radio 1 or radio 2.
AP Mode means the AP can receive connections from wireless clients and pass their data
traffic through to the Zyxel Device to be managed (or subsequently passed on to an
upstream gateway for managing).
MON Mode means the AP monitors the broadcast area for other APs, then passes their
information on to the Zyxel Device where it can be determined if those APs are friendly or
rogue. If an AP is set to this mode it cannot receive connections from wireless clients.
Root AP means the radio acts as an AP and also supports the wireless connections with
other APs (in repeater mode) to form a ZyMesh to extend its wireless network.
Repeater AP means the radio can establish a wireless connection with other APs (in either
root AP or repeater mode).
Note: To prevent bridge loops, do NOT set both radios on a managed AP to
Note: The root AP and repeater AP(s) in a ZyMesh must use the same country
Note: Ensure you restart the managed AP after you change its operating mode.
Radio 1/2 AP Profile Select an AP profile from the list. If no profile exists, you can create a new one through the
Create new Object menu.
Radio 1/2 Profile Select a monitor profile from the list. If no profile exists, you can create a new one through
the Create new Object menu.
Radio 1/2 ZyMesh This field is available only when the radio is in Root AP or Repeater AP mode. Select the
Profile ZyMesh profile the radio uses to connect to a root AP or repeater.
Enable Wireless This field is available only when the radio is in Repeater AP mode.
Bridging
Select this option to enable wireless bridging on the radio.
The managed AP must support LAN provision and the radio should be in repeater mode.
VLAN and bridge interfaces are created automatically according to the LAN port's VLAN
settings. When wireless bridging is enabled, the managed repeater AP can still transmit
data through its Ethernet port(s) after the ZyMesh link is up. Be careful to avoid bridge loops.
The managed APs in the same ZyMesh must use the same static VLAN ID.
Override Group Select this option to overwrite the AP output power setting with the setting you configure
Output Power here.
Setting
Output Power Set the output power of the AP.
Chapter 9 Wireless
Repeater AP mode.
code and AP radio profile settings in order to communicate with each
other.
ZyWALL USG Series User's Guide
277