2.
Install the boom section hose over the barbed
T-fitting at the center boom section and secure
the hose with a hose clamp
Note:
Apply a coat of liquid soap to the hose
barb of the tee fitting to ease installation of the
hose.
15
Installing the Nozzles
No Parts Required
Procedure
The nozzles that you use to apply your chemicals
vary depending on the rate of application that you
need; therefore, nozzles are not supplied with the kit.
To obtain the correct nozzles for your needs, contact
your Authorized Toro Distributor and be prepared to
give them then following information:
•
The target application rate in liters per hectare, US
gallons per acre, or US gallons per 1000 sq ft.
•
The target speed of the vehicle in kilometers per
hour or miles per hour.
To install a nozzle, complete the following:
1.
Thread or insert the nozzle into the nozzle
receptacle followed by a gasket.
2.
Slide the nozzle receptacle over the nozzle
fitting on a turret.
3.
Turn the nozzle clockwise to lock the cams on
the receptacle in place.
4.
Verify the fan portion of the nozzle.
See the Installation Instructions accompanying the
nozzles for more information.
(Figure
34).
31
16
Installing the Fresh-Water
Tank
Parts needed for this procedure:
1
Support tube (fresh water tank)
1
Jam nut (3/8 inch)
1
Bolt (3/8 x 1 inch)
2
Shoulder bolt
2
Locknut (3/8 inch)
1
Fresh-water tank
1
Fresh-water tank mount
2
Flanged locknut (5/16 inch)
2
Washer (5/16 inch)
2
Flanged-head bolt (5/16 x 2-1/4 inch)
4
Flanged-head bolt (5/16 x 5/8 inch)
Installing the Tank Support Tube
1.
Align the support tube for the fresh water tank
with the tank support channel
Figure 35
1. Support tube (fresh water
tank)
2. Jam nut (3/8 inch)
3. Front of the machine
4. Up
2.
Align the holes in the support tube with the holes
in the channel
(Figure
3.
Secure the tube to the channel
the 2 shoulder bolts and 2 locknuts (3/8 inch).
(Figure
35).
g028872
5. Bolt (3/8 x 1 inch)
6. Locknut (3/8 inch)
7. Weld nut (tank support
channel- fresh water
8. Shoulder bolt
35).
(Figure
35) with