Toro Multi Pro WM 41240 Operator's Manual page 77

Figure 106
1. Hairpin (5/32 x 2-5/8 inch)
2. Clevis pin (1/2 x 4-1/2
inch)
6. Align the hole in the top of the jackstand with the
hole in the frame of the tank skid
7. Secure the jackstand to the receiver and the
frame with 2 clevis pin (1/2 x 4-1/2 inch) and 2
hairpins (5/32 x 2-5/8 inch) as shown in
106.
8. Repeat steps 7 through
jackstands at the other side of the tank skid.
Removing the Sprayer Skid
1. Lower booms to approximately 45° and then
pivot them forward
Figure 107
3. Jackstand receiver
4. Rear jackstand
(Figure 106)
Figure
7 for the front and rear
(Figure 107).
2. Remove the 2 bolts (1/2 x 1-1/2 inches) and
a 2 locknut (1/2 inch) that secure the hold
down bracket of the tank skid assembly to the
bed bracket on the frame at each side of the
machine; refer to
(page 25).
3. Raise the tank skid with the lift cylinders, install
the cylinder lock, and perform the following:
Note:
Refer to
(page 60).
•
For HD- and HDX-Series Workman models
with a manual transmission, disconnect the
PTO shaft from the transaxle PTO; refer
to the installation instructions for the Multi
Pro WM Turf Sprayer Finishing Kit, Manual
Workman Utility Vehicle.
•
For HDX Workman with a automatic
transmission, disconnect the hoses at the
high-flow hydraulic panel and cap the fittings;
refer to the installation instructions for the
Multi Pro WM Turf Sprayer Finishing Kit,
g028423
Automatic Workman Utility Vehicle.
•
Disconnect the speed sensor wiring;
refer to
Harness (HD-Series Models with a Manual
Transmission) (page 20)
Speed Sensor Harness (HDX-Auto Model)
(page
4. Remove the cylinder lock and lower the tank
skid with the lift cylinders; refer to
Tank Assembly (page
5. Attach the lifting equipment to the horizontal
tubes of the forward jackstands and the vertical
post of the rear jackstands
6. Lift the tank assembly 7.5 to 10 cm (3 to 4
inches), and remove the lynch pins and clevis
pins securing the lift cylinders to the tank
assembly.
7. Lift the tank skid from the machine high enough
to clear the skid from the machine
8. Carefully move the vehicle forward and away
from the tank skid.
9. Slowly lower the skid tank to the ground.
g028736
77
11 Lowering the Tank Skid
Raising the Tank Assembly
Connecting the Speed Sensor
and
21).
61).
(Figure
Connecting the
Lowering the
107).
(Figure 107).