Toro Multi Pro WM 41240 Operator's Manual page 38

Flowmeter
The flowmeter measures the flow rate of the fluid to
the boom section valves
Boom-Section Valves
Use the boom-section valves to turn the sprayer
pressure on or off to the sprayer nozzles in the left,
center, and right boom sections
Boom Section-Bypass Valves
The boom section-bypass valves
the fluid flow from a boom to the tank when you turn
off the boom section. You can adjust these valves to
ensure that the boom pressure remains constant no
matter which combination of booms you are operating;
refer to Calibrating the Boom Bypass (page
Figure 45
1. Left boom section-bypass
valve
2. Center boom
section-bypass valve
Agitation-Throttle Valve
This valve is located on the rear left side of the tank
(Figure 46). Turn the knob on the valve to the 6
o'clock position to turn on the tank agitation and to the
8 o'clock position to turn off the tank agitation.
(Figure 44).
(Figure 44).
(Figure 45) redirect
55).
3. Right boom
section-bypass valve
1. Agitation-control valve
Note:
HD-series models with a manual
transmission—for agitation to work the PTO and
clutch must be engaged and the engine must be
running above an idle. If you stop the sprayer and
need agitation circulating the content of the tank,
place the range shift lever in the Neutral position, let
out the clutch, set the parking brake, and set the hand
throttle (if equipped).
Sprayer Pump
g028485
The sprayer pump is located at the rear of the machine
(Figure 47).
1. Sprayer pump
38
Figure 46
Figure 47
g028484
g028857