Installing Boom Holders; Before Operating; Filling The Fresh Water Tank - Toro 41229 Operator's Manual

Installing Boom Holders

Install the boom holder assemblies included with the
Spray System when installing the Boom Kit. Use the
Boom Kit Installations Instructions for more information
on installing the boom extensions.
1. Install the left boom holder assembly included in the
spray system loose parts to the tank skid frame when
the center boom is installed as shown in figure 23,
using 1 bolt (1/2 x 1-1/4 inches), 1 bolt
(1/2 x 3 inches), and 2 flange nuts (1/2 inch). The
fasteners used are in the boom kit.
2. Repeat Step 1 to install the boom holder on the right
side.
Note: The spray system is now prepared for the continued
installation of the Boom Kit. Refer to the Boom Kit
Installations Instructions for more information.
1
5
2
3
Figure 23
Left side shown
1. Left boom holder
assembly
2. Bolt, 1/2 x 1-1/4 inch
3. Bolt, 1/2 x 3 inch
4
6
7
m–7154
4. Flange nut, 1/2 inch
5. Frame mounting bracket
6. Frame
7. Center boom
20

Before Operating

Filling the Fresh Water Tank

The sprayer is equipped with a fresh water tank (Fig. 24)
for you to wash chemicals off of your skin, eyes, or other
surfaces in the case of accidental exposure. Always fill the
fresh water tank with clean water before handling or
mixing any chemicals.
1
2
3
Figure 24
1. Filler cap
2. Fresh water tank
To open the fresh water tank spigot, turn the lever on the
spigot toward the front of the sprayer.
3. Spigot