Coupling The Sprayer Pump; Installing The Control Console And Electrical Harness - Toro Multi Pro WM 41240 Operator's Manual

1. Existing speed sensor plugs
3. Connect the 3-pin connector for the vehicle
circuit of the wiring harness of the sprayer into
the 3-pin socket for the vehicle circuit of the
wiring harness for the machine.
Connecting the Speed Sensor
Harness (HDX-Auto Model)
1. At the wiring harness for the sprayer, locate the
3-socket connector for the speed sensor circuit
(Figure 17).
1. 3-pin connector (machine
wiring harness—speed
sensor)
2. 3-socket connector
(sprayer wiring
harness—speed sensor)
3. Hydrauliic tank
Figure 16
Figure 17
4. Rear-frame tube
5. Back of the machine
6. Right side of the machine
2. Connect the 3-pin connector of the wiring
harness of the machine for speed sensor into
the 3-socket connector of the sprayer harness
for the speed sensor
7

Coupling the Sprayer Pump

No Parts Required
Procedure
g024088
•
For HD-series models with a manual transmission,
couple the PTO shaft to the transaxle PTO; refer
to the Installation Instructions for the Multi Pro WM
Turf Sprayer Finishing Kit, Manual Workman Utility
Vehicle.
•
For HDX-Auto model—connect the hydraulic
motor hoses to the quick-disconnect fittings at the
high-flow hydraulic panel; refer to the Installation
Instructions for the Multi Pro WM Turf Sprayer
Finishing Kit, Automatic Workman Utility Vehicle.
8
Installing the Control
Console and Electrical
Harness
Parts needed for this procedure:
1 Knob
3 J-clips
1 Bolt (1/4 x 3/4 inch)
1 Flange nut (1/4 inch)
Installing the Control Console to
g028436
the Machine
1. Remove the hairpin securing the pivot pin of the
control console to the storage bracket on the
sprayer tank.
2. Install the control console onto the control
mounting bracket and secure the control console
with the previously removed hairpin
21
(Figure 17).
(Figure 18).