Toro Multi Pro WM 41240 Operator's Manual page 30

1. Nut
2. Washer
3. R-clamp
2. Secure the boom hoses to the front side of the
center boom section
with 1 R-clamp, 1 shouldered bolt (5/16 x 1 inch),
1 locknut (5/16 inch) and 1 washer (5/16 inch).
3. Install the boom section hose over the barbed
T-fitting at the boom section and secure the hose
with a hose clamp
Note:
Apply a coat of liquid soap to the hose
barb of the tee fitting to ease installation of the
hose.
4. Repeat steps 1 through
boom section on the other side of the sprayer.
Hose—Right Boom Segment
4. Shoulder bolt
5. T-fitting
6. Hose clamp
(Figure 32 and Figure
(Figure 32 and Figure
3 on the hose to the
Figure 33
Installing the Center Boom-Section
33)
Hose
1. Route the center boom-section hose as shown
in Figure
33).
1. Up
2. T-fitting
3. Hose clamp
30
7. Right-boom hose
8. Right-section valve
34.
Figure 34
4. Center-boom hose
5. Center-section valve
6. Front of the machine
g028469
g028471