Pre-Maintenance Procedures; Accessing The Machine - Toro Multi Pro WM 41240 Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or bystanders.
Remove the key from the ignition and disconnect the wire(s) from the spark plug(s) before
you do any maintenance. Set the wire(s) aside so that it does not accidentally contact the
spark plug(s).
Pre-Maintenance
Procedures

Accessing the Machine

Raising the Tank Assembly
DANGER
The sprayer tank assembly represents a
stored energy hazard. If not properly retained
when installing or removing the assembly,
it can move or fall and injure you or other
bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance when the
retaining fasteners are being removed.
An empty tank assembly can be tipped or raised up
to allow full access to the engine and other internal
components. Pivot the boom extension forward to
distribute the weight more evenly. Use the following
procedure:
1. Park the vehicle with an empty tank on a level
surface.
2. Use the -
BOOM CONTROL
boom extension to approximately 45°.
3. Stop the machine, engage the parking brake,
and remove the key.
4. Remove the safety bolts from the front of the
skid (Figure 77).
Figure 77
1. Bolt (1/2 x 1-1/2 inches)
switches to raise the
g022366
2. Locknut (1/2 inch)
5. Fold the boom extensions forward, alongside
the tank assembly to distribute the weight more
evenly, and keep it from tipping backward.
6. Raise the tank assembly until the lift cylinders
are fully extended.
7. Remove the bed support from the storage
brackets on back of the ROPS panel
1. Bed support
8. Push the bed support onto the cylinder rod,
making sure that the support end tabs rest on
the end of cylinder barrel and on the rod end of
the lift cylinder
60
(Figure
Figure 78
(Figure 79).
78).
g002397