Removing The Existing Bed; Procedure - Toro Multi Pro WM 41240 Operator's Manual

1

Removing the Existing Bed

No Parts Required

Procedure

CAUTION
The full bed weighs approximately 95 kg (210
lb), so do not try to install or remove it by
yourself. Get the help of 2 or 3 other people
or use an overhead crane.
1. Ensure that the parking brake is set and start
the engine of the machine.
2. Move the hydraulic lift lever forward and lower
the bed until the clevis pins for the cylinder rod
end lift cylinders are loose in the mounting slots
of the bed mounting plates.
3. Release the hydraulic lift lever, set the hydraulic
lift lock lever, and shut off the engine; refer to the
Operator's Manual of your machine.
4. Remove the lynch pins from the outer ends of
the cylinder rod clevis pins
1. Cylinder rod end
2. Bed mounting plate
3. Clevis pin
5. Remove the clevis pins securing the cylinder rod
ends to the bed mounting plates by pushing the
(Figure 3).
Figure 3
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
pins toward the centerline of the
3).
6. Remove the lynch pins and clevis pins securing
the pivot brackets of the bed to the frame
channels of the machine
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
7. Lift the bed off the vehicle.
8. Stow the lift cylinders in storage clips.
g002368
15
machine(Figure
(Figure 4).
Figure 4
4. Clevis pin
5. Lynch pin
g002369