Toro Multi Pro WM 41240 Operator's Manual page 74

2. Assemble the master-boom-valve manifold,
gasket, and master boom bypass valve with a
clamp tightened hand tight (A of
3. Align the flange of the master-boom-valve
manifold, a gasket, and the agitation-valve
manifold (B of Figure
4. Assemble the master-boom-valve manifold,
gasket, and agitation valve manifold with a
clamp and tighten by hand (B of
5. Align the flange of the master-boom-valve
manifold, a gasket, and the 90° flanged elbow
(at the end of the hose for the flow meter; refer
to B of Figure 103).
6. Assemble the master-boom-valve manifold,
gasket, and 90° flanged elbow with a clamp and
tighten by hand (B of
7. Assemble the agitation valve to the valve mount
with the flanged-head bolt and flanged locknut
that you removed in step
Master Boom Manifold Valve (page
torque the nut and bolt to 1017 to 1243 N-cm
(90 to 110 in-lb).
Installing the Section Manifold
Valve
1. Insert the upper endcap fitting of the manifold
valve into the bypass fitting (A of
Note:
If needed, loosen the mounting hardware
for the bypass fitting as needed to provide
clearance.
Figure 103).
103).
Figure 103)
Figure 103).
2 of Removing the
68)and
Figure 104).
1. Flange (reducer coupling)
2. Socket (bypass fitting)
3. Bypass fitting
4. Flange (adjacent
manifold—agitation valve)
5. Endcap fitting (manifold
valve assembly)
2. Secure the endcap fitting to the bypass fitting by
inserting a retainer into the socket of the bypass
fitting (A of Figure
3. Assemble the outlet fitting onto the lower endcap
fitting of the manifold valve (A of
4. Secure the endcap fitting to the outlet fitting by
inserting a retainer into the socket of the outlet
fitting (A of Figure
5. Align a gasket between the flanges of the
reducer coupling and the section valve manifold
(B of Figure 104).
6. Assemble the reducer coupling, gasket, and
section valve manifold with a clamp and tighten
by hand ( B of
7. If installing the 2 left most section valves, align
a gasket between the flanges of the 2 adjacent
section valve manifolds (B of
8. Assemble the and 2 adjacent section valve
manifolds and gasket with a clamp and tighten
by hand (B of
9. For the left or right boom section valves,
assemble the valves to the valve mount with
the flanged-head bolt and flanged locknut that
you removed in step
Manifold Valve (page 69)
and bolts to 1017 to 1243 N-cm (90 to 110 in-lb).
74
Figure 104
6. Socket (outlet fitting)
7. Retainer
8. Flange (manifold—section
valve)
9. Gasket
10. Flange clamp
104).
Figure
104)
Figure 104).
Figure
Figure 104).
3 of Removing the Section
and torque the nuts
g028245
104).
104).