Preparing To Install The Tank Skid - Toro Multi Pro WM 41240 Operator's Manual

2
Preparing to Install the
Tank Skid
Parts needed for this procedure:
Rear PTO Kit, Heavy-Duty Workman Vehicle
1
(HD-Series Models with a Manual Transmission)
Multi Pro WM Turf Sprayer Finishing Kit, Manual
1 Workman Utility Vehicle (HD-Series Models with a
Manual Transmission)
1 Hairpin
1 Control console
Multi Pro WM Turf Sprayer Finishing Kit, Manual
1 Workman Utility Vehicle (HD-Series Models with a
Manual Transmission)
Multi Pro WM Turf Sprayer Finishing Kit, Automatic
1
Workman Utility Vehicle (HDX-Auto Model)
Installing the Rear PTO Kit for
Heavy Duty Workman Vehicles
(HD-Series Models with a Manual
Transmission)
For HD- and HDX-Series Workman models with
a manual transmission, fully install the Rear PTO
Kit for Heavy-Duty Workman Vehicles; refer to the
Installation Instructions for the Rear PTO Kit for Heavy
Duty Workman Vehicles.
High-Flow Hydraulics Kit,
Workman HDX-Auto Utility Vehicle
(Non-TC—HDX-Auto Model)
Fully install the High-Flow Hydraulics Kit for Workman
HDX-Auto Utility Vehicles; refer to the Installation
Instructions for the High-Flow Hydraulics Kit,
Workman HDX-Auto Utility Vehicle.
Lifting the Sprayer Skid
Using lifting equipment with a 408 kg (900 lb) lift
capacity, lift the tank skid from the shipping crate at
the 2 front and 2 rear lift points
Note:
Ensure that the tank skid is raised high enough
to install the jackstands.
(Figure 5).
1. Rear lift point
Installing the Control Console
Note:
This step temporarily mounts the control
console to the tank while you assemble the sprayer
to the machine. You will complete the installation of
the control console in
Block (page 22).
1. Carefully remove the control console from the
shipping container
2. Align the pivot pin on the control console with the
storage bracket at the front tank strap
1. Control console
2. Storage bracket (front tank
strap)
3. Assemble the console to the bracket and secure
the pivot pin to the bracket with the hairpin
(Figure 6).
16
Figure 5
2. Front lift point
9 Installing the Sprayer Fuse
(Figure
Figure 6
3. Hairpin
g023738
6).
g028846