Greasing The Boom Hinges; Spray System Maintenance; Inspecting The Hoses - Toro Multi Pro WM 41240 Operator's Manual

Greasing the Boom Hinges

Service Interval: Every 100 hours
Important:
If the boom hinge is washed with
water, all water and debris must be cleared from
the hinge assembly and fresh grease must be
applied.
Grease Type: No. 2 general-purpose, lithium-based
grease.
1. Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Pump grease into the bearing or bushing at
each fitting Figure
Figure 81
Right boom
1. Grease fitting
3. Wipe off excess grease.
4. Repeat this procedure for each boom pivot.
81.
Spray System
Maintenance
WARNING
Chemical substances used in the spray
system may be hazardous and toxic to you,
bystanders, animals, plants, soils or other
property.
• Carefully read and follow the chemical
warning labels and Material Safety Data
Sheets (MSDS) for all chemicals used, and
protect yourself according to the chemical
manufacturer's recommendations. For
example, use appropriate Personal
Protective Equipment (PPE) including
face and eye protection, gloves, or other
equipment to guard against personal
contact with the chemical.
• Keep in mind there may be more than 1
chemical used and information on each
should be assessed.
• Refuse to operate or work on the sprayer if
this information is not available!
• Before working on a spray system
make sure the system has been triple
rinsed and neutralized according to
the recommendations of the chemical
manufacturer(s) and all of the valves have
been cycled 3 times.
g002014
• Verify that there is an adequate supply
of clean water and soap nearby, and
immediately wash off any chemicals that
contact you.

Inspecting the Hoses

Service Interval: Every 200 hours
Every 400 hours/Yearly (whichever comes first)
Examine each hose in the spray system for cracks,
leaks, or other damage. At the same time, inspect the
connections and fittings for similar damage. Replace
any hoses and fittings if they are damaged.
62