Removing The Boom-Section Valves; Removing The Boom-Section Hoses - Toro Multi Pro 1750 Installation Instructions Manual

5
Removing the Boom-Section
Valves
No Parts Required

Removing the Boom-Section Hoses

1. At the outer-boom section, remove the hose clamp
that secures the supply hose for the boom section to
the barbed T-fitting
Note: Retain the hose clamp for installation in
Installing the Supply Hoses to the Boom Sections
(page 39)
Figure 14
1. Outer boom section
2. Supply hose (outer-boom
section)
3. Barbed T-fitting
2. Remove the hose from the T-fitting
3. Remove the free end of the hose from the R-clamp
(Figure 14).
4. Repeat steps 1 through
other outer-boom section.
5. Under the center-boom section, remove the hose
clamp that secures the supply hose for the boom
section to the barbed T-fitting
(Figure 14).
4. Hose clamp
5. R-clamp
(Figure 14).
3 for the supply hose at the
(Figure 15).
Note: Retain the hose clamp for installation in
Installing the Supply Hoses to the Boom Sections
(page 39).
1. Center boom-section valve 4. Supply hose (center-boom
2. Center-boom section
3. Left side of the machine
11
Figure 15
section)
5. Hose clamp
6. Barbed T-fitting