PLANET ECLIPSE GEO2 Operator's Manual page 22

adJustinG tHe VelocitY
when using your Geo2, you may wish to change the
velocity at which your Geo2 is firing. This is done by
inserting a 1/8" hex key into the adjuster screw at the
bottom of your Geo2 inline regulator and adjusting it
accordingly (see fiGure 7.1). by turning this adjuster
screw clockwise you decrease the output pressure of the
inline regulator and consequently the velocity, by turning
the adjuster screw counter clockwise you increase the
output pressure of the inline regulator and consequently
the velocity. On the bottom of the inline regulator there
are engraved arrows to illustrate which direction to turn
the hex key to make the relevant adjustment.
1
fiG 7.1
After each adjustment fire two clearing shots to gain an accurate
1
velocity reading. Never exceed 300fps.
22.