Alcatel-Lucent 1677 SONET Link Manual page 146

DLP-121
Is OCn module to be supported by VSCs?
16
Enter
17
ENT-STS1::AID::::STSMAP=VTFLOAT&VTCRS;
for every OC-n on working OCn module. Enter command for every working OCn
module in shelf that will use VSC resources. Refer to CKL-109.
where:
AID=STS-1 facility AID
&& ranging and & grouping allowed
Enter
18
ENT-VT1::AID;
in step 17. Refer to CKL-109.
where:
AID = VT1 facility AID
&& ranging and & grouping allowed
Go to step 21.
19
Enter
20
OCn module. Enter command for every remaining working OCn module. Refer to
CKL-109.
where:
AID=STS-1 facility AID
&& ranging and & grouping allowed
Have facilities been entered for all OC-n ports on every working OCn module?
21
Connect Fiber-Optic Jumper Cables
WARNING: Possibility of equipment damage. The optical receiver on the test
22
set could be damaged if excessive optical power levels are applied to the
receiver. Make sure the optical signal is within the maximum operating range
of the instrument before applying signal to the optical input port.
Is a GIGE module equipped in shelf?
23
4-102
If yes, go to step 17.
If no, go to step 20.
to provision only the first VT1 facility in every STS-1 provisioned
to provision the first STS-1 facility for every OC-n on working
ENT-STS1::AID;
If yes, go to step 22.
If no, go to step 11.
If yes, go to step 24.
If no, go to step 32.
Set Up GIGE and OCn Modules for Error-Free Verification Tests
Issue 01, September 2007
to provision the first STS-1 facility
3EM13850AD