Lop-Lamp Selection - Christie Boxer 4K Technical Reference

Command Description
option cards that have loop out. (Saved
value)
LOP–Lamp Selection
Selects a lamp to turn on or off while in limited power mode.
If LOP or LOP+MULT try to enable any lamps that are not installed, the command fails.
Commands
Command Description
LOP <lamp> Selects a lamp to turn on or off while in limited power
mode. This command is disabled while in the Power On
state. (Saved value)
LOP+MULT <value> Selects which lamps are meant to be active. At least
one lamp must be active. This command is only
available in full power mode. (Saved value)
Valid bitmapped fields:
LOP+MULT valid values
The model of projector determines the number of lamps in the projector.
Value Lamp A1
(bit0)
1 On
2 Off
3 On
4 Off
5 On
6 Off
Boxer 4K Serial API Commands Technical Reference
020-101697-05 Rev. 1 (07-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
• bit0 = Lamp A1
• bit1 = Lamp A2
• bit2 = Lamp A3
• bit3 = Lamp B1
• bit4 = Lamp B2
• bit5 = Lamp B3
Lamp A2 Lamp A3
(bit1) (bit2)
Off Off
On Off
On Off
Off On
Off On
On On
Serial API commands
Values
Values
1 = Lamp A1 (Default)
2 = Lamp A2
3 = Lamp A3
4 = Lamp B1
5 = Lamp B2
6 = Lamp B3
value = A bitmapped field
ranging from 1 to 63
63 = All lamps are active
(Default)
Lamp B1 Lamp B2
(bit3) (bit4)
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Lamp B3
(bit5)
Off
Off
Off
Off
Off
Off
36