Ken-Keypad Enable - Christie Boxer 4K Technical Reference

Command Description
This command is only available if video electronics are
on.
ITP+RMPL <grey Defines the starting (top/left) grey-level used for the
level> Horizontal Ramp, Vertical Ramp, and Diagonal Ramp
test patterns.
This setting has no effect when the ramp is moving
(such as ITP+RMPM is non-zero).
This command is only available if video electronics are
on.
ITP+GRDP <pitch> Defines the spacing between lines used for the Square
Grid and Diagonal Grid test patterns.
This command is only available if video electronics are
on.
ITP+GRDC <0 | 1> Enables multi-color or white-on-black grids for the
Square Grid or Diagonal Grid test patterns.
This command is only available if video electronics are
on.
ITP+GRDM <0 | 1> Enables moving or static grid for the Square Grid or
Diagonal Grid test patterns.
This command is only available if video electronics are
on.
KEN–Keypad Enable
Enables or disables the IR or wired keypad sensors.
Commands
Command Description
KEN+FRNT <0 | 1> Enables or disables the IR keypad sensor.
(Saved value)
KEN+REAR <0 | 1> Enables or disables the rear IR keypad
sensor. (Saved value)
KEN+WIRE <0 | 1> Enables or disables the wired keypad sensor.
(Saved value)
KEN+HDBT <0 | 1> Enables IR over HDBaseT. (Saved value)
Boxer 4K Serial API Commands Technical Reference
020-101697-05 Rev. 1 (07-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Serial API commands
Values
0 to 4095
0 (Default)
2 to 127
32 (Default)
0 = White-on-black
1 = Multi-color (Default)
0 = Static (Default)
1 = Moving
Values
0 = Disables the front IR keypad sensor
1 = Enables the front IR keypad sensor
(Default)
0 = Disables the rear IR keypad sensor
1 = Enables the rear IR keypad sensor
(Default)
0 = Disables the wired keypad jack
1 = Enables the wired keypad jack (Default)
0 = Disables IR over HDBaseT (Default)
1 = Enables IR over HDBaseT
32