Beckhoff EL3773 Documentation page 155

Text ID Type Place
0x4000 Warning
0x4001 Warning System
0x4002 Warning System
0x4003 Warning System
0x4004 Warning System
0x4005 Warning System
0x4006 Warning System
0x4007 Warning System
0x4008 Warning System
0x4101 Warning General
0x4102 Warning General
0x417F Warning General
0x428D Warning General
0x4300 Warning Encoder
0x4301 Warning Encoder
0x4400 Warning Drive
0x4401 Warning Drive
0x4402 Warning Drive
0x4405 Warning Drive
0x4410 Warning Drive
0x4411 Warning Drive
0x4412 Warning Drive
0x4413 Warning Drive
EL3773
Text Message Additional comment
Warning: 0x%X, 0x%X, General warning; parameters depend on event. See
0x%X device documentation for interpretation.
Warning: 0x%X, 0x%X,
0x%X
%s: %s Connection
Open (IN:%d OUT:%d
API:%dms) from %d.%d.
%d.%d successful
%s: %s Connection
Close (IN:%d OUT:%d)
from %d.%d.%d.%d suc-
cessful
%s: %s Connection (IN:
%d OUT:%d) with %d.
%d.%d.%d timed out
%s: %s Connection
Open (IN:%d OUT:%d)
from %d.%d.%d.%d de-
nied (Error: %u)
%s: %s Connection
Open (IN:%d OUT:%d)
from %d.%d.%d.%d de-
nied (Input Data Size ex-
pected: %d Byte(s) re-
ceived: %d Byte(s))
%s: %s Connection
Open (IN:%d OUT:%d)
from %d.%d.%d.%d de-
nied (Output Data Size
expected: %d Byte(s) re-
ceived: %d Byte(s))
%s: %s Connection
Open (IN:%d OUT:%d)
from %d.%d.%d.%d de-
nied (RPI:%dms not sup-
ported -> API:%dms)
Terminal-Overtempera- Overtemperature. The internal temperature of the ter-
ture minal exceeds the parameterized warning threshold
Discrepancy in the PDO- The selected PDOs do not match the set operating
Configuration mode.
Sample: Drive operates in velocity mode, but the ve-
locity PDO is but not mapped in the PDOs.
Warning: 0x%X, 0x%X,
0x%X
Challenge is not Ran-
dom
Subincrements deacti- Sub-increments deactivated (despite activated configu-
vated: %d, %d ration)
Encoder-Warning General encoder error
Drive is not calibrated: Drive is not calibrated
%d, %d
Starttype not supported: Start type is not supported
0x%X, %d
Command rejected: %d, Command rejected
%d
Invalid modulo subtype: Modulo sub-type invalid
%d, %d
Target overrun: %d, %d Target position exceeded
DC-Link undervoltage The DC link voltage of the terminal is lower than the
(Warning) parameterized minimum voltage. Activation of the out-
put stage is prevented
DC-Link overvoltage The DC link voltage of the terminal is higher than the
(Warning) parameterized maximum voltage. Activation of the out-
put stage is prevented
I2T-Model Amplifier - The amplifier is being operated outside the specifica-
overload (Warning) tion
- The I2T-model of the amplifier is incorrectly parame-
terized
Version: 2.5
Diagnosis
155