Beckhoff EL3773 Documentation page 153

Text ID Type Place
0x0001 Information System
0x0002 Information System
0x0003 Information System
0x1000 Information System
0x1012 Information System
0x1021 Information System
0x1024 Information System
0x1042 Information System
0x1048 Information System
0x1084 Information System
0x1100 Information General
0x1135 Information General
0x1157 Information General
0x1158 Information General
0x1159 Information General
0x117F Information General
0x1201 Information Communication Communication re-es-
0x1300 Information Encoder
0x1303 Information Encoder
0x1304 Information Encoder
0x1305 Information Encoder
0x1400 Information Drive
0x1401 Information Drive
0x1705 Information
0x1706 Information
0x1707 Information
0x170A Information
0x170C Information
0x170D Information
EL3773
Text Message Additional comment
No error No error
Communication estab- Connection established
lished
Initialization: 0x%X, 0x General information; parameters depend on event.
%X, 0x%X See device documentation for interpretation.
Information: 0x%X, 0x General information; parameters depend on event.
%X, 0x%X See device documentation for interpretation.
EtherCAT state change
Init - PreOp
EtherCAT state change
PreOp - Init
EtherCAT state change
PreOp - Safe-Op
EtherCAT state change
SafeOp - PreOp
EtherCAT state change
SafeOp - Op
EtherCAT state change
Op - SafeOp
Detection of operation Detection of the mode of operation ended
mode completed: 0x%X,
%d
Cycle time o.k.: %d Cycle time OK
Data manually saved Data saved manually
(Idx: 0x%X, SubIdx: 0x
%X)
Data automatically Data saved automatically
saved (Idx: 0x%X,
SubIdx: 0x%X)
Data deleted (Idx: 0x%X, Data deleted
SubIdx: 0x%X)
Information: 0x%X, 0x Information
%X, 0x%X
Communication to the field side restored
tablished This message appears, for example, if the voltage was
removed from the power contacts and re-applied dur-
ing operation
Position set: %d, %d Position set - StartInputhandler
Encoder Supply ok Encoder power supply unit OK
Encoder initialization Encoder initialization successfully completed
successfully, channel:
%X
Sent command encoder Send encoder reset command
reset, channel: %X
Drive is calibrated: %d, Drive is calibrated
%d
Actual drive state: 0x%X, Current drive status
%d
CPU usage returns in Processor load is back in the normal range
normal range (< 85%%)
Channel is not in satura- Channel is no longer in saturation
tion anymore
Channel is not in over- Channel is no longer overloaded
load anymore
No channel range error A measuring range error is no longer active
anymore
Calibration data saved Calibration data were saved
Calibration data will be Calibration data are not applied and saved until the
applied and saved after command "0x5AFE" is sent
sending the command
"0x5AFE"
Version: 2.5
Diagnosis
153