Otto Bock 1C20 ProSymes Instructions For Use Manual page 19

2) Place the prosthetic foot on the lamination anchor and bring it to the marked position.
3) Screw on and tighten the fine-threaded screw (installation torque: 46 Nm).
4) Optional: Cut the footshell in the proximal area and sand it to fit the shape of the socket.
5) Put the footshell on the prosthetic foot until it clicks onto the heel spring and slide the foam
into the forefoot area.
6 Maintenance
► A visual inspection and functional test of the prosthetic components should be performed
after the first 30 days of use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
7 Disposal
This product may not be disposed of with regular domestic waste in all jurisdictions. Disposal that
is not in accordance with the regulations of the country where the product is used may have a det­
rimental impact on health and the environment. Please observe the information provided by the
responsible authorities in the country of use regarding return, collection and disposal procedures.
8 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
8.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
9 Technical data
Size [cm]
Heel height [mm]
Structural height without spacer plate [mm]
Structural height with spacer plate [mm]
Product weight with lamination anchor, without foot­
shell [g]
Maximum body weight [kg]
Mobility Grade
1 Description du produit
INFORMATION
Date de la dernière mise à jour : 2017-04-26
► Veuillez lire attentivement l'intégralité de ce document avant d'utiliser le produit.
25 26
10 ±5
43
52
465 475
100 100 (stiffness 2)
125 (stiffness 3)
2 + 3
27 28
490 495
Français
19