Mounting
4.8 Mounting the protection cover
4.8
Mounting the protection cover
The protection cover of the hollow shaft is supplied as an assembly kit.
①
②
Figure 4-2
Procedure
1. Fit the output shaft.
2. Use a suitable cleaning agent to clean the contact surface of the protection cover
the gearbox.
3. Place the flat seal
4. Wet the screws
5. Place the washers on the screws
6. Screw on the protection cover
7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.
You have now installed the protection cover for operation.
❒
86
Screw with washer
Protection cover
Mounted protection cover for hollow shaft
③
.
①
with medium-strength adhesive, e.g. Loctite 243.
③
Flat seal
④
Gearbox housing
①
.
②
.
Operating Instructions, 07/2019, A5E47360747B AA
SIMOTICS S-1FG1 servo geared motor
②
on