Mounting The Fan Cover; Canopy; Mounting A Rotary Pulse Encoder Under The Canopy; Reassembly: Miscellaneous Information - Siemens SIMOTICS SD Operating Instructions Manual

9.4.4.5

Mounting the fan cover

Fan cover
● When fitting the cover, do not overstretch it (risk of breakage).
● First engage two snap openings positioned next to one other, then carefully press the
● Latch all snap openings cleanly into the snap-in lugs.
9.4.4.6

Canopy; mounting a rotary pulse encoder under the canopy

Canopy; incremental encoder under the canopy
Guide the fixing screws through the holes on the external surface of the canopy and tighten
to a torque of 3 Nm ±10%.
9.4.4.7

Reassembly: Miscellaneous information

Miscellaneous
● Number and position of rating plates and additional labels as in original condition
● If necessary, fix cables in place.
● Check tightening torques of all screws, as well as those of screws which have not been
The number on the EC-type examination certificate for machines with flameproof enclosure
"d" type of protection is represented by an X, since the flameproof joints deviate from
EN / IEC 60079-1, Table 2. Only perform repairs following consultation with the manufacturer
and be sure to use original parts.
Low-voltage motors
Operating Instructions, 05/2014, 5 610 00000 02 000
cover into position with the two openings situated opposite these using the snap-in lugs,
and snap it into place.
unscrewed.
Maintenance
9.4 Corrective maintenance
101