Connecting
5.4 System integration
Removal of the RJ45 connector
Procedure
1. Turn the locking ring of the connector counterclockwise into the "unlocked" position.
①
2. Check that the two tabs are disengaged from the latches.
3. Pull the connector out of the RJ45 socket of the Sensor Module.
You have now released the DRIVE-CLiQ connection.
❒
5.4.4.3
Handling the quick-action locking
The motors are equipped with SPEED-CONNECT connectors.
You can also connect quick-connection cables with SPEED-CONNECT to motor connectors
as conventional cables with screw locks (fully threaded).
Note
We recommend cables with SPEED-CONNECT because they are easier to use.
122
Turn the locking ring counterclockwise.
→ Both tabs are pressed away by the latches.
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 07/2019, A5E47360747B AA