Inspection And Maintenance; Maintenance And Inspection Intervals - Siemens SIMOTICS S-1FG1 Operating Instructions Manual

Service and maintenance

9.2 Inspection and maintenance

9.2 Inspection and maintenance
9.2.1

Maintenance and inspection intervals

General
Carry out maintenance work, inspections and revisions at regular intervals in order to be able
to identify faults at an early stage and remove them.
Note
Inspection if there are faults or unusual conditions
Unusual conditions or faults that represent overstressing of the motor, e.g. overload or short-
circuit, can result in consequential damage to the machine.
Immediately perform an inspection when faults or exceptional conditions occur.
Maintenance measures, inspection/maintenance times intervals
The maintenance intervals depend on the operating conditions.
● Adapt the maintenance intervals to match the local conditions, such as pollution/dirt,
switching frequency, load, etc.
● Perform the following maintenance measures as specified in the table.
Maintenance and repair of the geared motor can be performed by Siemens Service Centers
throughout the world.
Consult your Siemens representative (http://www.siemens.com/industry/contact) if you
require this service
NOTICE
Improper maintenance
Service and maintenance must only be performed by properly authorized qualified
personnel.
Use only original SIEMENS parts.
142
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 07/2019, A5E47360747B AA