Service and maintenance
9.2 Inspection and maintenance
9.2.4.9
Oil quantities
Safety guidelines
NOTICE
Damage to the gearbox caused by incorrect oil quantities
Incorrect oil quantities can cause gearbox damage.
• Check the oil level before commissioning.
Note
You can find detailed information about oil quantities at DT Configurator
(http://www.siemens.com/dtconfigurator).
9.2.5
Checking the gearbox for leaks
Note
From the inherent principle of operation, oil mist can escape from the vent valve or a
labyrinth seal.
Small quantities of oil or grease can escape at the shaft sealing ring during the run-in period
of 24 hours operating time.
If significant leaks occur, or if a leak persists after the run-in period, replace the shaft sealing
ring.
This prevents follow-on damage.
Shaft sealing rings are subject to natural wear. The service life depends on the rated
conditions.
156
SIMOTICS S-1FG1 servo geared motor
Operating Instructions, 07/2019, A5E47360747B AA