The Print Heads Do Not Move; What To Do First; If The Heads Still Do Not Move - Roland VersaUV LEF2-200 User Manual

The Print Heads Do Not Move

If the print-head carriage stops over the flat table, take action immediately to prevent the heads from drying out.

What to Do First

Switch the sub power off and then back on again. If the print heads move to the home position (inside the panel
cover), it means the operation has ended successfully.

If the Heads Still Do Not Move

Try switching off the main power, then switching on the main power again, followed by the sub power.

If the Heads Still Do Not Move

If the heads still do not move, carry out the following emergency response measure, and then contact your au-
thorized Roland DG Corporation dealer.
Procedure
1.
Switch off the main power, and then open the front cover.
2.
Gently move the print-head carriage to the home position by hand.
Stopping at the place where the audible click is heard locks the print-head carriage in place.
3.
Close the front cover.
183
2. Machine Problems