Roland VersaUV LEF2-200 User Manual page 129

Maintenance That Must Be Performed Daily
5.
Set the print area.
Set the print area for the printing test. For a printing test, set the print area with a "WIDTH" of 90 mm (3.5 in.) or
more and a "LENGTH" of 70 mm (2.8 in.) or more. An error will occur and printing tests cannot be performed if the
area is smaller than this.
Procedure
1.
Press [▲], [▼], [▶] or[◀] when the following screen appears.
SCAN:
FEED:
The flat table and the print heads move so that the pointer points at the previously set printing base posi-
tion.
2.
Press [▲], [▼], [▶] or [◀] to move the pointer until it points to a position in the right foreground of the print area.
3.
Press [ENTER].
The print heads return to the home position and the following screen is displayed.
WIDTH: XXX.Xmm
LENGTH:XXX.Xmm
MEMO
• The previously set values are displayed for "WIDTH" and "LENGTH."
• When the object to be printed on comes into contact with the head gap sensor, the setup is canceled and the screen shown
below appears. Redo from
CHECK TABLE
When "CLEARANCE MODE" is set to "RE-ADJ." (
61) ), the setup is not canceled and operation continues.
4.
Press [▲], [▼], [▶] or [◀] to set the "WIDTH" to 90 mm (3.5 in.) or more and the "LENGTH" to 70 mm (2.8 in.) or
more.
The pointer moves until it points to a position in the inner left of the print area.
128
2. Regular Maintenance
0.0mm
0.0mm
5.The height of the object to be printed on is detected automatically.(P. 38)
HEIGHT
Adjusting the Distance between the Object to Be Printed On and the Print Heads(P.
.