Roland VersaUV LEF2-200 User Manual page 72

5.
Set the print area.
For a printing test, set the print area with a "WIDTH" of 90 mm (3.5 in.) or more and a "LENGTH" of 70 mm (2.8 in.)
or more. An error will occur and printing tests cannot be performed if the area is smaller than this.
Procedure
1.
Press [▲], [▼], [▶] or[◀] when the following screen appears.
SCAN: 0.0mm
FEED: 0.0mm
The flat table and the print heads move so that the pointer points at the previously set printing base posi-
tion.
2.
Press [▲], [▼], [▶] or [◀] to move the pointer until it points to a position in the center of the print area.
MEMO
When the pointer is difficult to see
Depending on the material of the object to be printed on, such as transparent media or high-gloss media with dark colors used
on the print surface, the pointer may be difficult to see. In such cases, the pointer may become more visible by placing masking
tape on the print surface or on the back.
3.
Press [ENTER].
The print heads return to the home position and the following screen is displayed.
WIDTH: XXX.Xmm
LENGTH:XXX.Xmm
MEMO
• The previously set values are displayed for "WIDTH" and "LENGTH."
• When the object to be printed on comes into contact with the head gap sensor, the setup is canceled and the screen shown
below appears. Redo from
CHECK TABLE
When "CLEARANCE MODE" is set to ""RE-ADJ"." (
canceled and operation continues.
4.
Press [▲], [▼], [▶] or [◀] to set "WIDTH" and "LENGTH" to values that match the width and length of the print area.
5.
Close the front cover when it is open.
6.
Press [ENTER].
The print area is specified. Print heads return to the standby position.
4.The height of the object to be printed on is detected automatically.(P. 70)
HEIGHT
Enabling Automatic Height Adjustment during Printing(P. 62)
Print Area Settings
.
), the setup is not
1. Optimizing the Setup Method
71