Roland VersaUV LEF2-200 User Manual page 43

Printing method
8.
Performing Normal Cleaning
If, after viewing the results of the printing test, dot drop-out or dot displacement is still present, perform normal
cleaning.
Procedure
1.
Press [▼] several times to display the screen shown below.
CLEANING
NORMAL CL.
2.
Check for the group with dot drop-out or dot displacement by viewing the results of the printing test.
Missing blocks indicate dot drop-out. Collapsed or inclined blocks indicate dot displacement.
The space from "A" to "B" is group A. The space from "B" to the right side is group B.
The following figure shows the "TEST PRINT 2" test pattern.
MEMO
If the printing-test results are difficult to interpret
Examine the results from different angles in a well-lit location. It is visible using the reflection of the light.
3.
Press [▶].
4.
Select the group of print heads to clean.
(1) Press [◀] or [▶] to select the group of print heads that is not to be cleaned.
ﾉｰﾏﾙ
AB
(2) Press [▲] or [▼] to get rid of the group display.
NORMAL CL.
A
(3)
Repeat steps 1 and 2 to display only the group of print heads that requires cleaning.
Only the displayed groups will be cleaned. If A and B are displayed, they will both be cleaned.
5.
Press [ENTER].
The screen shown below appears, and then cleaning starts. The (approximate) remaining time for the proce-
dure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 sec-
onds")
CLEANING...
>>
When finished, the screen shown below appears again.
42
1. Printing Operations
01:45